Raspberry Pi 2 Snap Shut Case

Here is my Raspberry Pi case for my Raspberry Pi 2, I think it will probably fit the Raspberry Pi 3 as well. It is an economical print and therefore quite quick to print out.

It is a snap shut design, with push in feet, the tolerances are quite tight but it fits and snaps together perfectly with a hardly visible seem.

To snap it shut, squeeze the top and bottom together at the corners,print 4 feet off and push the feet in, you may need to use a bit of force. Dont snap it together without the Pi in because once its snapped together its quite hard to split again.

Enjoy....

Oh yeah, you will probably need to rotate the parts to print, should be printed on the bottom of the bottom and top of the top