Raspberry Pi 3.5" piTFT

Remixed from [this thing](https://www.thingiverse.com/thing:3602609)

Inset 3.5" adafruit 2441 piTFT with risers printed.

I print the base vertical with a brim and supports everywhere.

Warning!!

the standoffs for the pitft are a bit short, put in a washer or couple tiny o-rings between the standoff and the pitft screen. the pitft may crack on tightening if you don't put something in that space there was a little bugger of material on the backside that upon tightening the screen cracked on me