Thingiverse
Raspberry Pi 3 B/B+ Lower Case Horizontal Mount
von Dj1001
3
Downloads
0
Likes
0
Makes
Remixed lower half of the OctoPi case designed by artieh. This half positions the Pi mounts horizontally which can allow for different mounting locations on you printer.
This remix is specifically for Pi 3 using M2.5 Screws.
Original file from Artieh was "Case_Rear_without_Ears_V3_25MM"
This remix is specifically for Pi 3 using M2.5 Screws.
Original file from Artieh was "Case_Rear_without_Ears_V3_25MM"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!