Thingiverse
Raspberry Pi 3 B+ Case
by Teknosherpa
141
Downloads
87
Likes
2
Makes
This is a clean RPi 3 B+ case. I created it taller to make room for a on/off switch and custom LEDs.
I used 20mm M3 bolts for the case and 6mm M3 bolts to secure the RPi inside the case.
EDIT 8/30/18: I switched the side the bolts are installed. This way you can use shorter bolts and then the heads double as feet for air circulation.
I used 20mm M3 bolts for the case and 6mm M3 bolts to secure the RPi inside the case.
EDIT 8/30/18: I switched the side the bolts are installed. This way you can use shorter bolts and then the heads double as feet for air circulation.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
