Raspberry Pi 3 desktop stand mount

This is a mount for a Raspberry PI 3/3+ to use on a desktop or flat surface and present the top of the rasPI at a 60 degree angle from horizontal. You should also be able to use it with RasPi cases that expose the mounting holes in the same place as the motherboard.

There are two flavors, the high profile and low profile. The low profile is good for most cases, but the high profile is good if you need a little more space between the motherboard and the desktop it is sitting on.

It is designed for M2.5 bolts, roughly 20-25 mm, in length, depending on if you are also mounting on a case. The bolts are a little on the snug side in the initial v1 revision, but they do fit through.

I designed this to mount a "pi1541", a Raspberry Pi-based Commodore floppy drive emulator after not being able to find a design for a mount design that held the Pi at an angle. See about the pi 1541 project [here](https://cbm-pi1541.firebaseapp.com/)

I am fine with people printing and selling prints