Raspberry Pi 3 Digital Stand-in

This is a 3d model of a Raspberry Pi 3 that I modeled and printed as part of a Pi3 printable case project I also made.

I made it so I could print it and compare it to my actual Raspberry Pi3 to verify my dimensions were correct in my model and to verify my printer's relevant accuracy.

Major dimensions (bolt holes, component locations) were taken from a detailed drawing from the Pi Foundation. Other, lesser dimensions were take by me from an actual Pi3 with a SAE dial caliper (I need to get a metric caliper) and converted to metric - rounded to the nearest .25mm in most cases. So dimensions are not perfect. But they're close enough to design a case around.

The GPIO pins are represented by a box that marks their extent.

Included are two models.

One complete - with the (minimal) bottom detail in tact (SD card reader, GPIO pin solder points, and whatever chip is on the bottom).

The other is a flat bottom model (omitting the SD card reader, GPIO solders, and whatever chi