Raspberry Pi 3A+ with DAC+ (PiFi) Case

This is a two-part case for a Raspberry Pi Model 3A+ with a Raspberry Pi (IQaudio) DAC+ designed to assemble with brass standoffs and machine screws, although the case snaps right together and will probably hold the electronics well enough without any screws assuming the two boards are ~11mm apart.

To assemble, start by putting standoffs on both sides of the DAC+ (11mm on bottom & 20mm on top). Leave the standoffs on the back by the GPIO headers very loose, or you won't be able to fit it in! Slide the DAC+ into the case top diagonally with the audio connectors first, line them up with their holes, slide the GPIO side (with very loose standoffs) in after. Now tighten the two sets of headers in the back, and you can add the pi, again diagonally HDMI-side first, and then the GPIO pins should slide right into the DAC. Add your screws (longer screw on bottom) and you're done!