Thingiverse
Raspberry Pi 3B , Ender 3 Pro, Cooled Case
von Sam_232
9
Downloads
11
Likes
0
Makes
Hi,
Thanks for viewing! If you end up using this it would be great to see any makes!
One quick note - With this design the power cable must be fastened down to avoid catching on the bed level knobs (I just used some tape to attach the wire the top of the printers electronics housing which seems to work well)
Thanks,
Sam
Required hardware:
- Raspberry Pi 3B/3B+
- 4020 Blower Fan
- 3x M3x16 (Hex head)
- 2x M5x10 (Hex head)
- 2x M5 Drop in T-Nuts
- 6x M2.5x8 (Hex head)
- (optional) Cable ties
Thanks for viewing! If you end up using this it would be great to see any makes!
One quick note - With this design the power cable must be fastened down to avoid catching on the bed level knobs (I just used some tape to attach the wire the top of the printers electronics housing which seems to work well)
Thanks,
Sam
Required hardware:
- Raspberry Pi 3B/3B+
- 4020 Blower Fan
- 3x M3x16 (Hex head)
- 2x M5x10 (Hex head)
- 2x M5 Drop in T-Nuts
- 6x M2.5x8 (Hex head)
- (optional) Cable ties
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!