Thingiverse
Raspberry Pi 3B+ PSU Mount
von lathemaster
1
Downloads
2
Likes
0
Makes
This is a remix of derikwhittaker's Raspberry Pi PSU mount for Meanwell 350. I made 3 changes to his design.
1. All my PSUs had the mounting holes about 45mm from the top of the PSU so I lengthened the legs
2. Resized the mounting holes for the Pi to 3mm so the bushings were not needed
3. Shortened the over all thickness of the mounting plate to 5mm
My Cura settings are in the zipped .HTML File
Filament - ELEGOO Rapid PLA+
1. All my PSUs had the mounting holes about 45mm from the top of the PSU so I lengthened the legs
2. Resized the mounting holes for the Pi to 3mm so the bushings were not needed
3. Shortened the over all thickness of the mounting plate to 5mm
My Cura settings are in the zipped .HTML File
Filament - ELEGOO Rapid PLA+
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
