Thingiverse
Raspberry Pi 4 and Relay Case - 3D Printer Lighting
von Maker-Mike
2
Downloads
1
Likes
0
Makes
Case to hold Raspberry Pi 4 and a 4 relay board.
I used it to hold my printers Raspberry Pi and the relay board, to power an enclosure LED light switched on/off by Octolight (https://plugins.octoprint.org/plugins/octolight)
Full assembly instructions here
The case is held together by 4 screws (M3x6mm self tapping). There's 3 screw mount points on the sides to hang on the wall.
No supports required.
Update Nov 2025: Added a 25mm deeper version of the top for more space inside.
I used it to hold my printers Raspberry Pi and the relay board, to power an enclosure LED light switched on/off by Octolight (https://plugins.octoprint.org/plugins/octolight)
Full assembly instructions here
The case is held together by 4 screws (M3x6mm self tapping). There's 3 screw mount points on the sides to hang on the wall.
No supports required.
Update Nov 2025: Added a 25mm deeper version of the top for more space inside.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!