Raspberry Pi 4 B case - maximum airflow - snap fit

Raspberry Pi 4 B case with a very open design to allow maximum airflow, make sure to print with 100% the bottom part as the very small rounded posts the pi sits on will be too hollow otherwise (no other infill is used in the model so affect on print speed is close to non).

Snap fitting top so no screws needed, just print the upper & lower and stick them together.

The holder is designed to keep the board at an angle that once again allows more airflow.
***Updated holder*** now includes side arms circle to keep it from toppling over to the side

Using this I got temp down without any fans or heatsinks from ~80C to ~65C on a more closed "conventional" case