Raspberry Pi 4 B case
by Iamkaioken
88
Downloads
52
Likes
1
Makes
In looking there are some amazing RPi4B cases out there! However, I wanted to provide an option that easily accommodated both 30mm and 40mm fans. A 40x40x10 fan fits without issue, there are a few mm of headroom available. That said, I've yet to include a place for accessory ribbons to exit as I don't have anything that requires such cables.
The fan mounting holes require M3 bolts, I used button head ones of perhaps 11-13 mm in length to thread into the top mount holes. Do note, that I wanted it to be relatively clean so don't go over 13mm in thread length.
The case itself is closed with M2.5 hex cap heads, these were perhaps 5mm in length. They flush mount on the bottom to allow for optimal placement of rubber feet.
I hope you enjoy the case!
The fan mounting holes require M3 bolts, I used button head ones of perhaps 11-13 mm in length to thread into the top mount holes. Do note, that I wanted it to be relatively clean so don't go over 13mm in thread length.
The case itself is closed with M2.5 hex cap heads, these were perhaps 5mm in length. They flush mount on the bottom to allow for optimal placement of rubber feet.
I hope you enjoy the case!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
