Raspberry Pi 4 Case With Mount
di azurecomet
7
Download
4
Likes
0
Makes
This is Malolo's screw-less / snap fit Raspberry Pi 4 Case with mounting holes for #10 screws.
Fits screws with a 5mm shaft and a head of 5.1mm - 10mm
The mount guide is for putting in the screws without having to remove the raspberry pi from the case.
Update 9/6/2019: Lowered the bottom by 1mm. Original one was too close to the board so the screws had a chance of scratching the soldered pins (No damage to components. Solder blobs were just big). Also made the mount guide the same thickness as the bottom.
Fits screws with a 5mm shaft and a head of 5.1mm - 10mm
The mount guide is for putting in the screws without having to remove the raspberry pi from the case.
Update 9/6/2019: Lowered the bottom by 1mm. Original one was too close to the board so the screws had a chance of scratching the soldered pins (No damage to components. Solder blobs were just big). Also made the mount guide the same thickness as the bottom.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
