Raspberry Pi 4 Computer and Screen Case

BASIC DESCRIPTION

I built this case to keep a 10" pimaroni HDMI screen and my raspberry pi 4 together in a nice little case and also hold a battery and keyboard.

The base acts as a tray to place the rpi4, a folding keyboard, and a battery bank. (Specifics linked below if you'd like to use the same).

The lid is a container for the screen and pcb that controls the screen can be screwed into the cutout on the top with 2mm screws. This part of the case is fastened together on the top by 4 M3 screws.

The hinge for the lid are fastened by 2 more M3*25 screws, and two M2*25 screws and a nut for each.

The PCB for the screen was attached via two small laptop screws of about 2mm wide and 3-4 mm long.

No soldering required!!

SETTING EXPECTATIONS

This is a FDM 3D printed case with many parts (especially if you have a small printer). FDM 3D prints especially have some defects that can sometimes be eliminated through careful fine-tuning of settings - sometimes we just have to