Raspberry Pi 4 - Dimensionally Accurate

July 12, 2019:
This is no longer a remix. I started from scratch. I have a Pi 4 here at home now, and using the technical drawing and a micrometer, I am remaking this model. I'm trying to make things as accurate as possible.

Note that the flares on the ends of the micro-HDMI ports are where my dimensions are taken, so that if you design a panel to set this against, those flares will also fit through properly.

Changes:
* The bare area around each of the 4 mounting points is recessed into the models base by 0.1mm both from on top and underneath so that you can see the full width of the available mounting area. Take this into account when creating your model.

* Added CPU, RAM, WIFI, and MicroSD. MicroSD part is sized to INCLUDE the microsd card when inserted, so you can make adjustments as if the card were being used.

Extra details like each GPIO pin will eventually be done, but those changes won't be until after the majority of the models major components are finished.