Thingiverse
Raspberry Pi 4 Hi-Q Camera Bracket
door notameadow
1
Downloads
0
Likes
0
Makes
This is a bracket for a Raspberry Pi 4 enclosed in [Pimoroni's Aluminium Heatsink](https://shop.pimoroni.com/products/aluminium-heatsink-case-for-raspberry-pi-4?variant=29430673178707) and [Raspberry Pi High Quality Camera](https://shop.pimoroni.com/products/raspberry-pi-high-quality-camera).
It requires some manual work, namely you need to tap the 1/4 thread in one or all holes in the connecting part. Depending on the material you use for printing you may get away with just trying to force a screw into the hole.
The camera itself does have a 1/4 thread but using it with a Pi hanging at the back could put too much strain on its PCB, but of course that's anyone's choice.
The 'springs' at the sides are half artistic, half meant to prevent sagging of the Pi part under temperature while still allowing for the Pi to be taken in and out. Ask me how I found out this is needed :)
The FPC detour on the top is there because you cannot insert the tape with the heatsink on (at least, I
It requires some manual work, namely you need to tap the 1/4 thread in one or all holes in the connecting part. Depending on the material you use for printing you may get away with just trying to force a screw into the hole.
The camera itself does have a 1/4 thread but using it with a Pi hanging at the back could put too much strain on its PCB, but of course that's anyone's choice.
The 'springs' at the sides are half artistic, half meant to prevent sagging of the Pi part under temperature while still allowing for the Pi to be taken in and out. Ask me how I found out this is needed :)
The FPC detour on the top is there because you cannot insert the tape with the heatsink on (at least, I
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
