Thingiverse
Raspberry Pi 4 Low Profile Base
by meowson
0
Downloads
1
Likes
0
Makes
My first design. Wanted a base plate for my raspberry pi 4 and realized most designs didn't really fit my need. Felt like I wanted to share what I created.
## Requirements:
- 4 x (M2x6mm screws)
- 4 x (M2 nuts)
Depending on your printer, you may want to clean up the screw holes after print.
M2 nuts should be flush on the bottom.
##Notes:
Originally the 9 rectangles on sides were meant to be for M3 mounting points in case someone wanted to mount the backplate but I realized after print that the stands were too low. I'll most likely upload a newer version. For now, this was pretty sufficient.
## Requirements:
- 4 x (M2x6mm screws)
- 4 x (M2 nuts)
Depending on your printer, you may want to clean up the screw holes after print.
M2 nuts should be flush on the bottom.
##Notes:
Originally the 9 rectangles on sides were meant to be for M3 mounting points in case someone wanted to mount the backplate but I realized after print that the stands were too low. I'll most likely upload a newer version. For now, this was pretty sufficient.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
