Thingiverse
Raspberry Pi 4 Stand / Bed
von its3dhomestuff
1
Downloads
0
Likes
0
Makes
This is a 'bed' stand to hold the Raspberry Pi4 off the desk or furniture so the heat doesn't leave any marks. It was designed with the heat sink wrap on the Pi as shown. May fit other mods as well. Printed with standard PLA settings (65C bed, 220C printhead). 100% infill. Need to activate supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
