Raspberry Pi 40mm Fan Mount

** Printer settings **
0.2 mm
Outline: 2
3 top layer
3 bottom layer

I noticed that my Pi B3 got a little how while running so I got a little 5V fan. For that I needed a holder of some kind. But the fan was a little noisy, so I got a transistor to turn it off and on through the GPIO pins. While adding this to my mount I thought that status LED's would be nice.
The fan gives space for 3 LED (Green, Yellow, Red) and a transistor. With a little python script the temperature is read an and when then it turns on or of the leds and the fan depending on the temperature.

** You need **
+ 40mm 5V Fan
+ 40mm fan grill
+ 3x LED 3mm
+ 3x 56 Ohm resistor
+ 1x BC337 Transisitor
+ 4x M2,5x10mm spacer
+ 8x M2,5x4mm screws
+ 4x M2,5x16mm screws