Raspberry pi 5 case for 7" touch display 2

A spacious case for the Raspberry Pi 5 and its 7" touch display 2.To secure the touchscreen, I printed out 4 spacers/washers so the screws could be adjusted from the back side to get a good fit in the case. This will depend on the length of the screw you are using, though.For the feet, I used heated inserts in the case and then screwed the feet in place (M3x8mm).The back plate is fastened by 4 screws directly into the case (no inserts used) — M2.5x8mm.Side vents are just push-fit.I printed it on my P1S with a standard 0.20mm layer height.The indentation for the thin glass screen may need some sanding/work to get a flush fit. This is a bit individual depending on the Raspberry Pi screens.