Raspberry pi 5 case - no screws required

I couldn't find a good raspberry pi 5 case to print so here is one designed by me.

Features:

+ No supports necessary (There are curved overhangs around the HMDI / power ports but this printed fine on my ender 3)
+ No screws required
+ Lid snaps into place
+ Ribbon cables can be fed through grille on lid
+ Pi is attached to the case using pins and C clips which I've designed. The clips fit into the recesses on the underside of the case and the pins should click into place. Alternatively you can use M2.5 x 8 screws and M2.5 nuts. Please be careful when pushing the pins into the C clips not to slip and damage the pi.
+ Step file included so you can modify however you like

As there are some snap / clip in features on this print, the fit of the parts will depend on how well your printer is calibrated. I reccomend following the teachingtech video https://teachingtechyt.github.io/calibration.html. Everything fits together quite tightly on my ender 3.

Please print the pins h