Thingiverse
Raspberry Pi 5 Case
von fraxoquaks
11
Downloads
17
Likes
0
Makes
Designed this one myself, plenty of tolerance for an easy assembly.
Add the power button, place your Pi on the pegs and clip the top onto the bottom.
This case supports:
- 40mm fan
- Power button
- GPIO passthrough
If you have troubles with the power button, just cut the sides to make it rectengular.
It should help with the alignment.
Only insert the SD card AFTER you installed the case! Otherwise there are issues with the fit
Add the power button, place your Pi on the pegs and clip the top onto the bottom.
This case supports:
- 40mm fan
- Power button
- GPIO passthrough
If you have troubles with the power button, just cut the sides to make it rectengular.
It should help with the alignment.
Only insert the SD card AFTER you installed the case! Otherwise there are issues with the fit
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
