Thingiverse
Raspberry Pi 5 case
von plammers
30
Downloads
25
Likes
0
Makes
This is a quick remix from my Raspberry PI 4 case to fit the new Raspberry PI 5.
I added a little extra height and ventilation to allow for the official raspberry pi cooling solution.
The added button solution works but may need some filing or light sanding to keep the button from binding.
To secure the Raspberry Pi 5 to the bottom I used 2,9 x 6mm screws and to secure the top cover I used 2,9 x 19mm screws. This can also be done with M3 bolts but drilling or tapping will be needed.
STEP and F3D are added for your convenience.
* Edit 24-11-2023: The button was not easy to install so I changed the button setup slightly. All files are replaced.
* Edit 16-02-2025: I was told in a comment that the openings for the CSI ports (Camera ports) were too narrow. I widened the openings and added the changed top as a individual STL file. Also updated the STEP and F3D files.
I added a little extra height and ventilation to allow for the official raspberry pi cooling solution.
The added button solution works but may need some filing or light sanding to keep the button from binding.
To secure the Raspberry Pi 5 to the bottom I used 2,9 x 6mm screws and to secure the top cover I used 2,9 x 19mm screws. This can also be done with M3 bolts but drilling or tapping will be needed.
STEP and F3D are added for your convenience.
* Edit 24-11-2023: The button was not easy to install so I changed the button setup slightly. All files are replaced.
* Edit 16-02-2025: I was told in a comment that the openings for the CSI ports (Camera ports) were too narrow. I widened the openings and added the changed top as a individual STL file. Also updated the STEP and F3D files.
plammers veröffentlicht auch auf
10 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
