Thingiverse
Raspberry Pi 5 case
door cedricpii
1
Downloads
2
Likes
0
Makes
A raspberry Pi 5 case with :
- 1 RPI 5
- 2 RGB fans (40mm)
- 1 official M2 Hat+
Just print the body, the top (that you can magnetize) and the two grids with Half-Life logo.
The plots are optionals. They are used to support the M.2 Hat cause it does not rest on the GPIO ports. So you must have for it 4 x 25mm screws and 4 nuts. I used M3 screws for fans.
- 1 RPI 5
- 2 RGB fans (40mm)
- 1 official M2 Hat+
Just print the body, the top (that you can magnetize) and the two grids with Half-Life logo.
The plots are optionals. They are used to support the M.2 Hat cause it does not rest on the GPIO ports. So you must have for it 4 x 25mm screws and 4 nuts. I used M3 screws for fans.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
