Raspberry Pi 5 Sled - Makers Base Case

This is a sled or case for the Raspberry Pi 5. This is only the bottom part, it is designed for makers so all the ports are easily available. as you can see, there are cutouts for the power and HDMI. The SD card can easily be accessed from the bottom. The reset switch is also easy to access. There is NO top. It is intended for makers to access all the sockets and ports while keeping their desk and Raspberry Pi 5 clean and undamaged. There is space under the board, so if you want to secure a HAT, then there is room. about 2.5mm. This does depend where you are in the space, as the screw standoffs are not vertical but have a chamfer.PrintingThe file is 3mf, as I am unable to get Fusion 360 to export g-code. I wait hours and nothing downloads! This is only a model file. There is no slicing etc.I used eSun Fire Engine Red PLA+, but any non-conductive filament will work fine.Nozzle width: 0.4mmLayer height: 0.2mmInfill density: 20%Infill pattern: cubicUse your best temperatures for the filam