Thingiverse
Raspberry Pi 7" TouchScreen Fan Lid
by carlwilhelm
1
Downloads
0
Likes
0
Makes
I am using a Raspberry Pi 3b + with the official 7" TouchScreen and case as a screen for a surveillance camera.
It was running very hot, and i got warnings on screen for high temperature.
Designed a new back lid for the TouchScreen case with fan and vent holes.
I have versions for 3 different fans:
30mm (i used 30x7,5mm, but 30x10mm should also work fine)
40x10mm
40x15mm
All versions come with either screw holes for mounting the fan, and a alternate version if you have a finely tuned printer where the fan should press into place and no screws needed.
Pictures are of my first version wich is too thin and flimsy. The version published here is much nicer.
20.12.2022 - Updated all files. The top clips were a bit too wide.
It was running very hot, and i got warnings on screen for high temperature.
Designed a new back lid for the TouchScreen case with fan and vent holes.
I have versions for 3 different fans:
30mm (i used 30x7,5mm, but 30x10mm should also work fine)
40x10mm
40x15mm
All versions come with either screw holes for mounting the fan, and a alternate version if you have a finely tuned printer where the fan should press into place and no screws needed.
Pictures are of my first version wich is too thin and flimsy. The version published here is much nicer.
20.12.2022 - Updated all files. The top clips were a bit too wide.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
