Thingiverse
Raspberry Pi A+ Audio Project Enclosure
door vinceallen
19
Downloads
18
Likes
0
Makes
Print a simple enclosure for a [Raspberry Pi audio project](https://gist.github.com/vinceallenvince/7cae6fcfc78091475e81). I designed the enclosure around the [Raspberry Pi A+](http://www.newark.com/raspberry-pi/raspbrry-moda-256m/sbc-raspberry-pi-model-a-256mb/dp/93X7446) and the small [Veho](https://www.amazon.com/dp/B002CS2T4I/ref=cm_sw_su_dp) rechargeable speaker. It's meant to have a small physical footprint while protecting hardware components.
Including the fasteners, spacers and hardware, there are 34 total parts. The 3D parts require ~2 hours printing time. The hardware and fasteners cost ~$60.00.
The components pictured were printed on a MakerBot Replicator 2 at 0.2mm resolution. I used [Simplify3D](https://www.simplify3d.com/) to slice and arrange the pieces.
Make your own design with the [SCAD files](https://github.com/vinceallenvince/3DP/tree/master/RPiAplus).
Including the fasteners, spacers and hardware, there are 34 total parts. The 3D parts require ~2 hours printing time. The hardware and fasteners cost ~$60.00.
The components pictured were printed on a MakerBot Replicator 2 at 0.2mm resolution. I used [Simplify3D](https://www.simplify3d.com/) to slice and arrange the pieces.
Make your own design with the [SCAD files](https://github.com/vinceallenvince/3DP/tree/master/RPiAplus).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
