Thingiverse
Raspberry Pi A+ Mount for Adafruits Case
by dbltrbl023
17
Downloads
6
Likes
0
Makes
A mount for Adafruits Raspberry Pi A+ Case. ( https://www.thingiverse.com/thing:546427 )
Though i guess it will fit the Pi without the case if that´s your thing.
Mounts with drop-in t-nuts. Made for Ender 5 but will fit "anything".
For Ender5 users, if you decide to mount it like me (because of short 15cm camera cable). You´re in for a bit of hassle, but it works! Just a bit tricky to mount it on the inside of the Y-axis rod.
Beware though this will cover the HDMI port, didn´t matter for me since i´m not using it, but if you need it, just cut a hole in the model before printing. Or use only the left mount, it´s enough if you don´t mount it like me.
Also make sure to print both models and not just mirror the one, because the Adafruit case is NOT symmetrical...
Print with "back" down and support up to the part that mounts into the 2020 frame.
Though i guess it will fit the Pi without the case if that´s your thing.
Mounts with drop-in t-nuts. Made for Ender 5 but will fit "anything".
For Ender5 users, if you decide to mount it like me (because of short 15cm camera cable). You´re in for a bit of hassle, but it works! Just a bit tricky to mount it on the inside of the Y-axis rod.
Beware though this will cover the HDMI port, didn´t matter for me since i´m not using it, but if you need it, just cut a hole in the model before printing. Or use only the left mount, it´s enough if you don´t mount it like me.
Also make sure to print both models and not just mirror the one, because the Adafruit case is NOT symmetrical...
Print with "back" down and support up to the part that mounts into the 2020 frame.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
