Thingiverse
Raspberry Pi and 2-Ch Relay Case
door SuperPilot
37
Downloads
16
Likes
0
Makes
I wanted a case to keep my Raspberry Pi 3B+ and Relay board covered while also having a camera and temperature sensor to monitor/control my Garage using Homekit.I'm running HAP-NodeJS to run everything on the Pi.
I used Thing:1568750 for the camera case.
The relay can be found here: SunFounder 2 Channel Relay
The case doesn't require any screws to assemble. I glued the swivel piece to the top piece of the case and haven't had any issues but you could probably drill out the center for a screw.
I used Thing:1568750 for the camera case.
The relay can be found here: SunFounder 2 Channel Relay
The case doesn't require any screws to assemble. I glued the swivel piece to the top piece of the case and haven't had any issues but you could probably drill out the center for a screw.
SuperPilot publiceert ook op
16 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
