Raspberry Pi Cable Holder For Prusa Mount

I have used this RPi Camera mount for years [https://www.thingiverse.com/thing:247590] This is just a small addition to that otherwise awesome little thing.

My original one was PLA and it broke and I had a predecessor to this thing that I never posted. But since it finally broke after a few years I reprinted in PETG and decided to redesign my cable holder and then post it on here.

I have one of those cables that are like 3 miles long and my RPi is on the underside of my lack table so my camera cable can't just dangle or it would get caught on the bed and all sorts of bad things could happen.

These are pretty self explanatory. Though you could probably push them through the middle of two 'links' from the mount linked above I strongly recommend instead disassembling it, putting it between the links and then reassembling it. It has a notch at the back that keeps it from popping out but it also makes it tough to push through.

I don't think material or infill percentages ar