Raspberry pi cam surface/wall mount

I needed a means of mounting my pi camera inside of my printer enclosure. I don't like any of the printer-mounted camera case options and couldn't find anything else that fit my needs. Decided this would be a great learning project for Fusion, so away I went!

Printing:

Housing lock - you'll need one for each side (or only print 1 if you don't care about symmetry; It's not exactly an aesthetically pleasing case anyway)
Hinge - has an offset side so that you can print it laying on a flat side with no supports
All other parts can easily lay flat and be printed.

You'll need two m3 screws. I used 8mm in length, and had the screws self-tap. You could easily use longer ones and stop them with a nut, but it isn't necessary on such a low-impact print.

Printed in PLA with .3mm layer height (on a 0.8mm nozzle). As usual, thinner layers = better quality. I wouldn't recommend thicker than 0.3, though, as your screw holes will suffer.