Thingiverse
Raspberry Pi camera angle mount case
por Deagol
41
Descargas
14
Likes
0
Makes
This is a camera mount for the Raspberry Pi camera, that allows you to mount it in a square leg of an Ikea Lack printer enclosure, or simmilar, pointing down at a 45º angle. Perfect for a Printer monitoring or remote control system like Octopi.
The camera and the cover are held in place by six M2x4 screws. Although you could do with only 3 really.
The case itself can be attached to the table leg with double sided tape, or two dots of Sugru or hot glue. (Please forgive the crappy sticky tape of the picture... I was just trying to find the right height)
The camera and the cover are held in place by six M2x4 screws. Although you could do with only 3 really.
The case itself can be attached to the table leg with double sided tape, or two dots of Sugru or hot glue. (Please forgive the crappy sticky tape of the picture... I was just trying to find the right height)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
