Raspberry Pi Camera Arm and Base
por G4GCL
96
Descargas
66
Likes
0
Makes
This is an alternative arm for the excellent camera case designed by parkis. I wanted something to mount in an enclosure I have planned and didn’t need the rotation of a ball mount which is used in other designs. Until the enclosure is finished it is mounted on a block of wood as seen in the first pictire otherwise, with 2 Arm pieces (plus the Cam_Arm), it would fall over.
There are 3 files
1 – The file called Camera_Mount. This has centre marks to aid placing of two mounting screws in positions which allow maximum rotation. The slots will take M4 screws or equivalent,
2 – The file called Cam_Arm. One of these is needed to mount the camera.
3 – The file called Arm. As many of these as you need (if they are needed at all) to put the camera in the correct position.
So a minimum of one Cam_Arm and one Camera_Mount is needed. The Arm is only needed to extend the reach if required. The picture with the junior hacksaw is showing how I cleaned out the slots. It just needs to be pass
There are 3 files
1 – The file called Camera_Mount. This has centre marks to aid placing of two mounting screws in positions which allow maximum rotation. The slots will take M4 screws or equivalent,
2 – The file called Cam_Arm. One of these is needed to mount the camera.
3 – The file called Arm. As many of these as you need (if they are needed at all) to put the camera in the correct position.
So a minimum of one Cam_Arm and one Camera_Mount is needed. The Arm is only needed to extend the reach if required. The picture with the junior hacksaw is showing how I cleaned out the slots. It just needs to be pass
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!