Thingiverse
Raspberry Pi Camera Arm
von BennyL
145
Downloads
83
Likes
4
Makes
This is a remix project of a Raspberry Pi camera Arm. Instead of requiring bolts to attach the three pieces, each piece is connected via a ball joint, requiring no additional hardware.
This design allows the the arm to swivel and tilt with great degree.
The four grooves surrounding the receiving end of the joint allow the arm to tilt further past the top edge, by aligning the corner of the arm into the middle of the space (see the first picture).
This design can be edited using Tinkercad - https://tinkercad.com/things/9WGoSMfpmMw.
This design allows the the arm to swivel and tilt with great degree.
The four grooves surrounding the receiving end of the joint allow the arm to tilt further past the top edge, by aligning the corner of the arm into the middle of the space (see the first picture).
This design can be edited using Tinkercad - https://tinkercad.com/things/9WGoSMfpmMw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
