Raspberry Pi camera birds eye view mount

I wanted to make a birds eye view mount for my H2S and Raspberry Pi Camera 3 as I have a spare pi4 and camera left over from an old Creality Ender 5 pro plus and wanted a bit more of a higher image quality than the standard camera so I made this. It is direct fitment using the screw that is already there for the original birds eye view camera and the ribbon cable for the camera just goes out the top of the printer as shown in photos. I don't print high temperature materials (other than the mount for this camera) but according to the specs, the camera can be used in environments up to 60 degrees so should be ok for most materials. The photo shows the Pi Camera 3 STD and not the wide angle as trying to get hold of one at the moment (14-04-2026) is very hard as all are out of stock. But I would expect the FOV to be a lot better. I have my FOV currently setup to 1296x730 to get the most out of the FOV. Hope this like this and boost me is you appreciate the design. Thanks, Hal