Raspberry Pi Camera Case w/ NeoPixel Ring (12 LED)

habales was the only model I could find that would house both a Pi Camera and a 12 LED NeoPixel ring. Only problem, it wouldn't fit the Prusa MK2 Camera Bed Mount - Higher Arm

http://www.thingiverse.com/thing:2014167

So, after some massaging, I was able to come up with the same look, just add some legs to it so it could mount to the bed mount and increase its size a little so the walls were thicker to try and prevent light from bleeding out (didn't work like that with orange ABS). I also added the ability to print out a lens in a transparent filament. I would highly recommend PETG, or another transparent filament that can take high heat. That NeoPixel ring can get HOT! I would also recommend printing out the case in a filament that can take high heat. After about 2 minutes of a full on brightness, a case made with PLA failed miserably by the legs becoming useless and the camera falling off the mount, only to stop hitting the floor because of that weak ribbon cable & some 30awg si