Raspberry Pi camera mount for Ender 5

This is a very slim basic camera mount for the Ender 5. Since the bed moves down instead of the extruder, and the X/Y carriage makes the sides unusable, I designed a very slim mount to put directly in front of the extruder. The mount includes a section for a very small LED strip to light the bed. Used a wide angle camera to capture as much of the print as possible. Should be good for most small to medium size prints.

Parts:
Camera: https://www.amazon.com/gp/product/B07L2SY756
Camera connector ribbon: https://www.amazon.com/gp/product/B07SM6JTTM
LEDs: https://printermods.com/products/led-lighting-kit-for-3d-printers-hot-end-version
2x M3 16mm bolts
2x M3 T-nuts

Used PLA Plus since strength was not an issue.

Update 2/1/21: I found mounting the light on the inside of the front rail was causing me to lose too much build volume when couple with the Hero Me so I built this simple little bracket to mount from the outside of the frame and to look down a bit. Just bolt the mount o