Thingiverse
Raspberry Pi Camera Mount Plate
por jmsaltzman
2
Descargas
2
Likes
0
Makes
With this plate, mount a Pi camera in your case with ease.
To install, drill a 3/8" hole (maybe go 1/64" bigger if needed) and glue the plate on the inside of the case; the raised ring will fit into the drilled hole.
A pointy bit on the side of the plate indicates the camera's up-direction, as does an arrow in the front which can be handy if your case is transparent. (WHY IS THERE NO UP ARROW ON THE PCB?!)
M2 screws to hold the camera should thread nicely into the holes.
To install, drill a 3/8" hole (maybe go 1/64" bigger if needed) and glue the plate on the inside of the case; the raised ring will fit into the drilled hole.
A pointy bit on the side of the plate indicates the camera's up-direction, as does an arrow in the front which can be handy if your case is transparent. (WHY IS THERE NO UP ARROW ON THE PCB?!)
M2 screws to hold the camera should thread nicely into the holes.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
