Raspberry Pi Camera Ribbon Cable Guide - Ender 3

I wanted to use a Pi Camera instead of USB, but hated the idea of a loose ribbon cable. So to solve the problem, I created a flexible cable management for the ribbon cable. using the various parts you can cleanly route your camera cable. Each section pivots 180 degrees.

On my Ender 3, I used the excellent Pi case from
https://www.thingiverse.com/thing:3075921
and mounted it upside-down underneath the LCD display. I then glued my cable guide to the side of the case. The ribbon cable is routed between the upper and lower case pieces with no modifications required.

Hint: You can roll up quite a bit of Pi camera cable inside the case so you won't have to guess which length cable you need. I think mine is 3 meters, with most of it rolled up inside the case with a little tape to keep it from unraveling.

**Edit 1-15-2019. The above link has stopped working. I have included the files for the original PI case with slight modification for the camera cable access. There are