Raspberry Pi + Camera Suction Cup Window Mount

A suction-cup / window mount for a Raspberry Pi and its camera.

I used small suction cups from my local hardware story, removing the wire hook they came with so I could slide them into the printed frame instead. Possibly [these 1 1/8" ones](http://www.acehardware.com/product/index.jsp?productId=1273663).

I used the camera case and snap connectors from the Lulzbot design from nlaredo, and was inspired to clip onto the edge of the board by anykey's design

Note that the clip inserts must be printed horizontally, since printed layers are strongly cohesive, but one layer does not adhere to the next. If you print the the prongs of the clips pointing upwards, they break off instead of flexing.

[Here are the scripts (on GitHub)](https://github.com/markfickett/pitimelapse) I used to capture/process the time lapse.

I printed this in PLA, which deformed in direct sunlight: the frame holding the board bent, and the pins in the articulated arm for the camera loosened. I would recomme