Thingiverse
Raspberry Pi Case and Mount for Kossel
von kevinlo
118
Downloads
68
Likes
0
Makes
Remix :
http://www.thingiverse.com/thing:284923
http://www.thingiverse.com/thing:290443
I need to mount the Raspberry Pi Case on the Kossel 1515.
Since no GPIO needed for octoprint , so I modify the case without IR port and make the vented on the top and bottom of the case.
I also make two set mount.
One is for mount the case on horizontal.
One is for mount the case on vertical.
PS :
Update on 19/8/2014 , add top case support camera flat cable
http://www.thingiverse.com/thing:284923
http://www.thingiverse.com/thing:290443
I need to mount the Raspberry Pi Case on the Kossel 1515.
Since no GPIO needed for octoprint , so I modify the case without IR port and make the vented on the top and bottom of the case.
I also make two set mount.
One is for mount the case on horizontal.
One is for mount the case on vertical.
PS :
Update on 19/8/2014 , add top case support camera flat cable
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
