MakerWorld
Electronics
Model downloaden
Raspberry Pi Case Feet
0
Downloads
0
Likes
0
Makes
These feet are based off James Silvia's Raspberry Pi 5 case. The screws to mount the Pi in the case may stick past the bottom of the case. So I made these feet to fit over the screw ends, and allow use of hot glue or other method to place the feet. Can be used for any other case as feet or etc. They are made from TPU and are 10x10x2mm with an hole thats 5x5mm inset about 1mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!