Raspberry Pi Case for MPD NO AMS NEEDED

This is a case for a Raspberry Pi ( the mount plate should be able to mount a pi 3 to pi 5) and a 1602 i2c display and rotary encoder youll need some other hardware as well and a Raspberry Pi a USB to USB panel mount cable (I used a USB-C to micro USB since I had a 3b+ and I wanted to use USB-C, I purchased 1 from adafruit)A set of RCA Bulkhead jacks (not needed if your using a USB DAC, found mine on amazon)A 3.5 to RCA if you are using the bulkhead jacksA 1602 display A rotary encoderA small piece of acrylic smaller than 85mm x 30.5 (I used transparent black)wires for the 1602 and rotary encoderfeet (optional)m3 Nuts qty. 12 ( 8 for the top and bottom plates and 4 for the pi mount plate)m3 x 16 qty. 4m3 x 8 qty. 4m3 x 6 qty.8 (4 for the pi mount plate and 4 for the 1602)m2.5 x 10 qty. 4 (for mounting the pi to the mount plate)m2.5 nuts qty. 4 (for mounting the pi to the mount plate)m3 rubber feet and hardware to mount them (this is optional but the holes are there) you should be able