Thingiverse
Learning
Go to Model
Raspberry Pi case for Telescope Mount
50
Downloads
36
Likes
0
Makes
Tripod mounted raspberry pi case for astrophotography. Modeled for 1.75” legs.
Printing of the back case is really inconvenient. You will end up using lots of supports and they are a bit of a pain to remove. The final part works really well though.
-4pcs m3 bolts were used to secure the board inside the case
-4pcs m3 bolts were used to secure the two halves of the case
-2pcs m4 bolts for the clamp
-2pcs m4 nuts for the clamp
As a side note, if anyone using a raspberry pi to control imaging and guiding, is able to get their raspberry pi to run a guiding program that recognizes the AR0130 sensor, please message me. I am able to guide beautifully using my lap top and PHD2, But the PHD2 program on the astroberry server won’t recognize my AR0130 sensor for guiding. I have tried Indigo Sky and have had no luck there also. Any help with this would relieve a whole lot of frustration. Thanks.
Printing of the back case is really inconvenient. You will end up using lots of supports and they are a bit of a pain to remove. The final part works really well though.
-4pcs m3 bolts were used to secure the board inside the case
-4pcs m3 bolts were used to secure the two halves of the case
-2pcs m4 bolts for the clamp
-2pcs m4 nuts for the clamp
As a side note, if anyone using a raspberry pi to control imaging and guiding, is able to get their raspberry pi to run a guiding program that recognizes the AR0130 sensor, please message me. I am able to guide beautifully using my lap top and PHD2, But the PHD2 program on the astroberry server won’t recognize my AR0130 sensor for guiding. I have tried Indigo Sky and have had no luck there also. Any help with this would relieve a whole lot of frustration. Thanks.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
