Thingiverse
Raspberry Pi Case Seals
por webgiant
0
Descargas
2
Likes
0
Makes
I really liked the Raspberry Pi 3.5" TFT case, https://www.thingiverse.com/thing:1895374, but even with the clip the case wouldn't stay closed. Tape made it harder to get open and closed for future tinkering. Glue was just not something I wanted to do.
So I created these tight fitting case seals for the case. They fit on the top and the bottom, with a hole on the bottom to allow access to the microSD card, and do not block any ports or air vents. I printed them with 100% infill for maximum strength.
So I created these tight fitting case seals for the case. They fit on the top and the bottom, with a hole on the bottom to allow access to the microSD card, and do not block any ports or air vents. I printed them with 100% infill for maximum strength.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
