Thingiverse
Raspberry Pi Display Case
by ftobler
2.8k
Downloads
2.2k
Likes
36
Makes
A simple display case for the Raspberry Pi 2 & 3 Model B. I used a 3.5inch touchscreen LCD, which is purchased from ebay. Link and guide is listed below.
The micro SD card is accessible from outside. A special feature is, that it is held in place, even when the spring loaded mechanism of the sd slot fails (which happened here).
The raspi is entirely passive cooled. I have not used a heat sink or a fan.
Do not print assembly.stl. I have three different top parts. I only used and printed that width the display. I used some weak glue to bind the parts together.
#####In case you need some changes to the model to fit your Display, there is a [customizer][1]
If this is not enough for you, feel free to send me a message :)
User-specified models:
raspiBplusCase_top_differentCutout.stl
raspiBplusCase_top_extraTall.stl
[display is from ebay][2]
[guide to bring it to life][3]
(I used the raspbian image)
[1]: https://www.thingiverse.com/thing:2395
The micro SD card is accessible from outside. A special feature is, that it is held in place, even when the spring loaded mechanism of the sd slot fails (which happened here).
The raspi is entirely passive cooled. I have not used a heat sink or a fan.
Do not print assembly.stl. I have three different top parts. I only used and printed that width the display. I used some weak glue to bind the parts together.
#####In case you need some changes to the model to fit your Display, there is a [customizer][1]
If this is not enough for you, feel free to send me a message :)
User-specified models:
raspiBplusCase_top_differentCutout.stl
raspiBplusCase_top_extraTall.stl
[display is from ebay][2]
[guide to bring it to life][3]
(I used the raspbian image)
[1]: https://www.thingiverse.com/thing:2395
ftobler also publishes on
111 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
