Thingiverse
Raspberry Pi Ethernet Mount
door wihami
3
Downloads
3
Likes
0
Makes
These prints allow one to install a Raspberry Pi Camera mount to their Raspberry Pi without needing to print an additional case. This is done by mounting the pi by a block placed in the ethernet port of the Pi. The rod used to attach the mounting pieces was 5/16" aluminum rod and the bolt at the top is an M3 x 10 mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
