Thingiverse
Raspberry Pi FLIRC Stack with 2 HDD and USB hub
door SuddenlyPineapple
4
Downloads
3
Likes
0
Makes
Raspberry Pi Stack for FLIRC case, with cheap USB 3.0 Hub and two HDD disk with external case.
I've used cheap Chinese cases for HDD from Alibaba.
FLIRC case is for better cooling of Raspi,
Caution: If you plan on using the same usb hub as me you can have problem with booting raspi if you are gonna use Ubuntu Server as operating system, in other cases it will be fine. As a temporary solution, I just unplug power and turn on disks right after boot of raspi.
Some printing settings that I can recommend are as follows:
- 20% infill
- support (tree is the best one, I think)
- for better bed adhesion, it is recommended to use brim,
Version with OBJ file is available here (for 1$): https://cults3d.com/en/3d-model/various/raspberry-pi-flirc-stack-with-2-hdd-and-usb-hub
I've used cheap Chinese cases for HDD from Alibaba.
FLIRC case is for better cooling of Raspi,
Caution: If you plan on using the same usb hub as me you can have problem with booting raspi if you are gonna use Ubuntu Server as operating system, in other cases it will be fine. As a temporary solution, I just unplug power and turn on disks right after boot of raspi.
Some printing settings that I can recommend are as follows:
- 20% infill
- support (tree is the best one, I think)
- for better bed adhesion, it is recommended to use brim,
Version with OBJ file is available here (for 1$): https://cults3d.com/en/3d-model/various/raspberry-pi-flirc-stack-with-2-hdd-and-usb-hub
SuddenlyPineapple publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!