Raspberry Pi house

I added a small ridge on the top part edge off Tripnutz great design. Together with a small adaption on the bottom it enables the bottom to be clicked in the top and thus fixated. I also added a few small feet printed in ninjaflex. This will lift the case about 1.5mm up so that the bottom has sufficient airflow for the chip on the bottom of the pi. For most application I do not think a fan is necessary so I took the liberty to adapt a second top with a pi logo.
I printed it in PLA 0.1mm. It proved to be a good addition. The bottom is well fixated but it can still be easily disassembled.