Thingiverse
Raspberry Pi Mount for Black Case
von shaun6mc
4
Downloads
2
Likes
0
Makes
Needed to wall mount an older Raspberry Pi 2B that came with this black case.
I think some of Rpi 3s came with case as well.
Has two channels built in where a zip tie can feed through and secure the Case to the mounting plate.
x2 Holes are sized for #6 Machine Screws
The arrow points to where the SD card slot should be when attaching the case to this mount.
Need to use good zip ties. The channels are tight, so cheaper zip ties may not fit
*EDIT* - Added a stubby version too. Just a smaller version that would probably print x2 faster.
I think some of Rpi 3s came with case as well.
Has two channels built in where a zip tie can feed through and secure the Case to the mounting plate.
x2 Holes are sized for #6 Machine Screws
The arrow points to where the SD card slot should be when attaching the case to this mount.
Need to use good zip ties. The channels are tight, so cheaper zip ties may not fit
*EDIT* - Added a stubby version too. Just a smaller version that would probably print x2 faster.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
